Products Detail
PENTENS T-200H
UV Resistant Elastomeric Waterproofing Coating
PENTENS T-200H is based on newly developed water-based polyurethane and acrylic polymers. It dramatically reduces solar heat absorption in either air-conditioned or non-air-conditioned buildings. It takes the majority of the heat load of a building’s skin and reduces temperatures to approximately that of outside shade.
ADVANTAGES
USES
APPLICATION
Substrate should be primed with a 1:3 mixture of PENTENS T-007 and clean water. Brush on at the approximate rate of 0.2~0.3kg/m2. PENTENS T-200H is suggested to apply at least 2 coats. The first coat should be applied in one direction only. If possible the second coat should be applied at right angles to the first. Leave to cure for approximately 2 to 8 hours before applying second coat. PENTENS T-200H can be installed with conventional airless spray equipment, brush or roller. On areas exposed to hot drying winds, 2 to 3 thin coats of PENTENS T-200H may work better than 1 thick coat.
SAFETY
PENTENS T-200H is non-toxic. For personal precautions, applicators are recommended to wear gloves and goggles when handling PENTENS T-200H.
UV Resistant Elastomeric Waterproofing Coating
PENTENS T-200H is based on newly developed water-based polyurethane and acrylic polymers. It dramatically reduces solar heat absorption in either air-conditioned or non-air-conditioned buildings. It takes the majority of the heat load of a building’s skin and reduces temperatures to approximately that of outside shade.
ADVANTAGES
- High elongation.
- Can resist ponding water.
- Water-based, environmentally friendly.
- Air and UV protection.
- Easy-cleaning and weather resistant.
- Chemical resistance and waterproof.
- User-friendly, suitable to use on any surface.
- Adheres well over-aged, galvanized and metal roofs, wood, asphalt or aluminum coatings, polystyrene foam insulation, polyester plastic panels, precast flat concrete, and barrel cement tiles, and many roofing materials.
- Prevention of ravages of acid rain, freeze-thaw, cycles, sunlight, bacteria, and fungus.
- Non-toxic.
USES
PENTENS T-200H is a one-part elastomeric cross-linking latex copolymer emulsion designed as exposed waterproofing coating on:
- RC gutters and planter boxes
- Floor slabs
- Roof decks
- Wood siding / Fences
- External wall
- Flat roof
- Metal roof
- Concrete structures
APPLICATION
Substrate should be primed with a 1:3 mixture of PENTENS T-007 and clean water. Brush on at the approximate rate of 0.2~0.3kg/m2. PENTENS T-200H is suggested to apply at least 2 coats. The first coat should be applied in one direction only. If possible the second coat should be applied at right angles to the first. Leave to cure for approximately 2 to 8 hours before applying second coat. PENTENS T-200H can be installed with conventional airless spray equipment, brush or roller. On areas exposed to hot drying winds, 2 to 3 thin coats of PENTENS T-200H may work better than 1 thick coat.
SAFETY
PENTENS T-200H is non-toxic. For personal precautions, applicators are recommended to wear gloves and goggles when handling PENTENS T-200H.