|
2 |
Panels |
|
|
|
|
|
|
2.1 |
The modular square panel shall be 600rrirn x 600mm with manufacturing tolerance within 0.5mm All edges ore sealed with hard PVC trim in grey colour and with mitred corner joints. NO PVC trim for bare panels. |
|
2.2 |
The modular square panel shall consist of the following parts:-a, 25mm thick structural woodcore to comply to MS1036 1986 TYPE Ill, improved moisture resistant board. b. A die form steel trough of 20rnm depth and a top flat sheet, both 0.6mm thick, bonded to the woodcore, c. Hard tappered PVC edge trim along the sides of the woodcore. |
|
|
These parts are structurally laminated together by double gluing method using approved heat resistant adhesive to be specified and used under the manufacturer’s instruction. |
|
2.3 |
The edges of the panel are protected with hard PVC trimmings. These trimmings are chemically bonded with approved adhesives. |
|
2.4 |
The modular square panel shall be capable of discharging static electricity transversely, as specified i.e.:-a. ‘anli-static’ performance shall be within 1 x – 2 x ohms. b. ‘dissipative’ performance shall be within 1 x 10’ – 1 x 10° ohms. c. ‘conductive” performance shall be within 0.25x 10’-1 x 10’ ohms. |
|
2.5 |
The modular square panel shall be cladded with an approved galvanized steel sheet_ |
|
2.6 |
Floor covering as specified shall be laminated to the panel by double gluing method using an approved adhesive system being selected by the manufacturer Floor covering would not peel from the panel or create any formation of air cavity under normal usage or under specified environmental conditions. |
