Styrenated polyester-based 2-component anchoring adhesive.
Fast curing
Non-sag, even overhead
ETA for anchoring in uncracked concrete
Usage
As a fast curing anchoring adhesive for all grades of:
Rebars / reinforcing steel
Threaded rods
Bolts and special fastening systems
In the following substrates:
Concrete
Hollow and solid masonry
Hard natural stone*
Solid rock*
* These substrates may vary greatly, in particular with regard to strength, composition, and porosity. Therefore, for each application, the suitability of Sika Sika AnchorFix® S adhesive must be tested by first applying the Product only to a sample area. Check-in particular bond strength, surface staining, and discoloration.
Advantages
Fast curing
Non-sag, even overhead
ETA for anchoring in uncracked concrete
Low wastage
Colour
Component A: white
Component B: black
Component A+B mixed: light grey
APPROVALS / STANDARDS
CE marking and Declaration of Performance as Bonded injection type anchor for use in uncracked concrete according to EAD 330499-00-0601, based on ETA-13/0721 of 18/05/2018 and certificate of constancy of performance of the construction product issued by the notified product certification body.
Shelf Life
12 months from date of production
All Sika AnchorFix® S cartridges have the expiry date printed on the label.
Storage Conditions
Stored properly in original, unopened, sealed, and undamaged packaging in dry conditions at temperatures between +5 °C and +25 °C. Protect from direct sunlight.
Density
~1.7 kg/l (component A+B mixed)
Mixing Ratio
Component A : component B = 10 : 1 by volume
Layer Thickness
3 mm max.
Sag Flow
Non-sag, even overhead
Product Temperature
Sika AnchorFix® S must be at a temperature of between +5 °C and +40 °C for application.
Ambient Air Temperature
+5 °C min. / +40 °C max.
Dew Point
Beware of condensation.
The substrate temperature during application must be at least 3 °C above the dew point.
SUBSTRATE QUALITY
Mortar and concrete must be at the required strength. No need to be 28 days old.
Substrate strength (concrete, masonry, natural stone) must be verified.
Pull-out tests must be carried out if the substrate strength is unknown.
The anchor hole must always be clean, dry, free from oil and grease, etc.
Loose particles must be removed from the holes.
Threaded rods and rebars have to be cleaned thoroughly from any oil, grease, or any other substances and particles such as dirt, etc
